17. November 2012 · Comments Off on Cisco ASA 5500 Dual ISP Connection [Failback] · Categories: Cisco · Tags: , , , , ,

Starting from version 7.2(1) and upwards, the Cisco ASA 5500 series firewall supports now the Dual-ISP capability. You can connect two interfaces of the firewall to two different ISPs and use the new “SLA Monitor” feature (SLA=Service Level Monitoring) to monitor the link to the primary ISP, and if that fails, the traffic is routed to the Backup ISP.

asa 5500 dual isp connection

Assume that the Primary ISP (ISP-1) has assigned to us the public IP address with gateway Also, the Backup ISP (ISP-2) has assigned us the public IP with gateway Normally all traffic should flow through ISP-1, but if the physical link (or route) to that ISP fails, then traffic should be redirected to the Backup ISP. We can configure an SLA monitor service which will be checking every 30 seconds (using a ping echo request) the availability of the primary Gateway IP address ( If there is no response in 20000 milliseconds (20 sec), then the default route will be redirected to the Backup ISP. The configuration is shown below:

asa5500(config)# sla monitor 100
asa5500(config-sla-monitor)# type echo protocol ipIcmpEcho interface outside
asa5500(config-sla-monitor-echo)# timeout 20000
asa5500(config-sla-monitor-echo)# frequency 30
asa5500(config)# sla monitor schedule 100 life forever start-time now
asa5500(config)# track 1 rtr 100 reachability
asa5500(config)# route outside 1 track 1
asa5500(config)# route backup-isp 254

Of course the configuration above assumes that you have already configured two interfaces connected to the ISPs, the first one with name ‘outside’ (security level 0) and the second one with name ‘backup-isp’ (security level 1).

Comments closed.